Bio-medical engineering

Design of Natural Hybrid Composite for Prosthetics Denture

Project academic year
Abstract
This study investigates the design and evaluation of a natural hybrid nanocomposite material based on polymethyl methacrylate (PMMA) reinforced with hydroxyapatite (HA) and eggshell powder (ESP) for use as a prosthetic denture base material. PMMA has long been the standard material for denture fabrication due to its biocompatibility and ease of processing. However, its relatively poor mechanical properties — including low fracture toughness, brittleness, and limited flexural strength — remain a significant clinical concern. To address these limitations, natural fillers were incorporated as eco-friendly and biocompatible reinforcing agents. Four specimen groups were prepared using a cold-cure hand lay-up method: pure PMMA (control), and three reinforced groups containing 3 wt.% ESP combined with 1, 3, and 5 wt.% HA, respectively. Mechanical testing included compression, bending, and Vickers hardness tests, while physical testing covered water absorption and density measurements. Results showed that increasing HA content significantly improved bending strength — from 46.08 MPa in pure PMMA up to 71.76 MPa at 5 wt.% HA — and surface hardness, which rose from 8.14 HV to 16.00 HV. Compressive strength remained relatively stable across all groups. Water absorption was lowest in the 3HA–3ESP group (1.29%), and density increased with filler addition, peaking at 1.022 g/cm³ for the same group. These findings suggest that PMMA reinforced with hydroxyapatite and eggshell powder offers improved mechanical and physical properties, making it a promising, sustainable, and biologically compatible alternative for denture base applications.
Keywords
PMMA
hydroxyapatite
egg shell powder
denture composite

Preparation of Biodegradable Polymer Composite for bone fixation

Project academic year
Abstract
This study presents the preparation and characterization of a biodegradable polymer composite based on Polylactic Acid (PLA), Chitosan (CH), and Hydroxyapatite (HA) for potential applications in bone fixation and tissue engineering. PLA was selected as the primary biodegradable polymer matrix due to its favorable biocompatibility and biodegradability, while chitosan and hydroxyapatite were incorporated to enhance the biological and mechanical performance of the composite. Several composite formulations with different concentrations of CH and HA were fabricated using the solvent casting technique with chloroform as a solvent. The preparation process involved magnetic stirring, ultrasonic treatment, and casting in glass Petri dishes to improve homogeneity and reduce structural defects. Different experimental trials were conducted to optimize the fabrication procedure and achieve uniform composite samples with minimal air bubble formation and improved structural integrity. The prepared samples were characterized through hardness testing, surface roughness analysis, water absorption evaluation, and antibacterial activity assessment to determine their suitability for biomedical applications. The results demonstrated that the incorporation of hydroxyapatite and chitosan significantly influenced the physical and mechanical properties of the prepared composites. The sample containing 3% CH and 1.5% HA exhibited the highest hardness value, indicating enhanced mechanical stability due to the reinforcing effect of the ceramic phase. In addition, the composite containing 2% CH and 1% HA showed the lowest surface roughness value, suggesting improved filler dispersion and surface uniformity. Overall, the developed PLA/CH/HA biodegradable composites demonstrated promising characteristics for potential use in temporary bone fixation devices and orthopedic applications. The combination of biodegradability, improved mechanical behavior, and bioactive properties suggests that these composites may provide an effective alternative to conventional non-biodegradable fixation materials.
Keywords
PLA
Chitosan
Hydroxyapatite
bone fixation